TM 11-5895-846-14
c. Open the alarm monitor drawer.
d. On the rear panel, disconnect all cables from
the chassis connectors J1, J2, and J3 and ground wire
Figure 5-25. Alarm Monitor, Rear Panel.
e.
Release the latches on the slide rails and
remove the alarm monitor from the rack.
f.
Replace the alarm monitor by performing steps
through e above in reverse order.
Section XIII. MAINTENANCE OF ANTENNA AS-3036/TSC
5-47.
Scope
circuit
breakers
on
the
power
distribution panel
are
in the OFF
This section contains instructions and procedures for
position.
removal and replacement of the actuators, motor- brake
a.
WARNING
for painting and lubrication instruction, respectively.
Use two persons for this task, otherwise
personal injury and/or damage to the
5-48.
Removal and Replacement
equipment may result. Do not attempt
this task if winds exceed 40 mph (64
WARNING
km/h).
Do not attempt any removal or
replacement unless the equipment is in
a nonoperating condition and all power
5-68